4

Testing a power supply 每 Noise (III)

By author316 2013-09-11

Switching transient noise

Switching transient noise is the noise generated when the PWM switches change state. The transient spike is a higher frequency spike or a sequence of spikes often in the form of a damped sine wave (...

Read More
4

Testing a power supply 每 Noise (Part 2)

By author244 2013-09-11

Measuring line transient performance

Line transients are the droop and/or overshoot that takes place on the output of a power supply when an instantaneous change in input voltage takes. The transient amplitude is a function o...

Read More
4

Testing a power supply 每 Stability

By author236 2013-09-11

Introduction

This is the third and final part in a three-part series which discusses how to properly test a power supply to ensure it will work reliably over various operating conditions. The series is intended to provide the design...

Read More
4

Testing a power supply 每 Noise

By author195 2013-09-11

How to properly test a DC/DC power supply to ensure it works reliably over various operating conditions. The series is intended to provide the design engineer with a sufficient understanding about some, but not necessarily all, of the testing needed to veri...

Read More
4

Testing a power supply - Introduction

By author76 2013-09-11

Introduction  

All too often system designers employ a power circuit without thoroughly ensuring its proper operation throughout operating extremes. Situations exist where prototypes work fine, so further power supply testing ...

Read More
4

Choose The Right Switching Regulator

By author62 2013-09-11

Manufacturers sell different types of switching regulators. The location of the storage elements in reference to the switching elements and their quantities generally determines the type of switching supply configuration, as can be seen in various architect...

Read More
4

7 Steps In Switching Power Supply Design

By author77 2013-09-11

The design of switching power supplies requires significant attention to detail, from component placement and thermal analysis to careful testing for a wide range of operating conditions. 

Switching power supplies are inevitable in today’s ...

Read More
Home pagePrevious page1Next pageLast page